Protocol S2Y
Protocol S2Y calls for the addition of DMSO (dimethyl sulfoxide) to the solution on an hourly basis. DMSO itself also reduces pain, decreases swelling, reduces inflammation, promotes healing, is antifungal, dissolves blood clots, and restores normalcy to the body.
For 50 years, it has been used for health purposes to help the body absorb medications and nutrients. It has been used to dissolve blood clots in the body by oral administration. It is used for short or long-distance transfer of transplanted organs from the donor to the recipient for preservation.
Overview
This protocol simply adds DMSO to the MMS1 dose of Protocol 1000, which is 3 drops per hour to activate the drops. With Regimen S2Y, add 3 drops of DMSO per drop of MMS, or if you have not progressed to 3 drops per hour at this point, continue with the same amount of MMS1, but add only DMSO.
Basic
Allergy Warning :Very few people are allergic to DMSO, usually people with weak livers. To test if you are allergic, please perform the following test:
- Wash and dry the stains on your arms. (The top or bottom of the elbow is fine.) q Apply a drop of DMSO to the arm wash and rub (with clean hands).
- Knead and soak for about 15 minutes and let stand for 24 hours.
- If there is no pain in your liver area after 24 hours, then the use of DMSO may be
It is safe to say that 999 out of 1000 people have access to DMSO.
Because MMS can heal the liver, if you have been taking MMS1 for more than a week, your liver may tolerate DMSO without problems.
If you are having an adverse reaction to DMSO, I recommend that you do the initiation procedure and continue with Protocol 1000 to improve your liver condition. If you have used these protocols and still have an adverse reaction to DMSO, simply continue using the protocols and repeat the same test again in a few days and you should achieve a tolerance to DMSO. If the second test fails, continue with the protocols and try the test every few days until it passes. In the past 60 years, there have been no reports of any permanent harm to humans from DMSO.
Protocol S2Y Description
Step 1.
- Activate 3 drops of MMS. (If you have not been able to reach the 3-drop dose due to nausea, etc., activate the number of drops you are taking).
- Add 1/2 cup of water.
Step 2.
- Immediately after adding water, add DMSO (3 drops of DMSO for every drop of MMS). For example, if you make 3 drops of MMS1 dose, add 9 drops of DMSO.
- Once DMSO is added, drink the solution immediately; if left, MMS1 will begin to slowly lose potency.
Step 3.
– If you feel sick after adding DMSO to your dose (e.g., nausea, diarrhea, etc.), then reduce DMSO by 50% at the next dose. if you still feel sick, reduce DMSO by another 50%. If you are still uncomfortable after two dose reductions, stop adding DMSO altogether for one day. Then start over with a smaller dose of DMSO, slowly increasing to 3 drops of DMSO per drop of MMS.
Important Notes :
The important reason to drink the MMS/DMSO solution immediately is because dimethyl sulfoxide begins to slowly deprive the solution of its potency. Although it takes 6 hours to lose its full potency, it is best to drink it immediately so it does not lose any of its strength. I recommend drinking dimethyl sulfoxide drops within 1 minute of adding them because it loses a significant amount of potency in the first 10 minutes and then continues to lose potency at a slower rate.